There is absolutely a tire pressure monitoring system (TPMS) that works with your iPhone or Android phone:
- 4 Tire Sensors: TireMinder Smart TPMS for RVs # TPMS-APP-4
- 6 Tire Sensors: TireMinder Smart TPMS for RVs # TPMS-APP-6
The way it works is the system comes with a Bluetooth adapter that gets the data from the tire sensors. That adapter then sends the data to your iPhone so you can see it. The systems come with either 4 tire sensors or 6 tires sensors but will allow you to monitor... view full answer...
The TireMinder i10 TPMS for RVs and Trailers w/ Signal Booster # TM56FR will work just fine with a towed vehicle that already has built in TPMS sensors. The sensors for the vehicle's built in TPMS are inside of the wheel, and the # TM56FR threads onto the valve stem allowing both sensors to be used.
I included a video of the # TM56FR being installed for you to take a look at. view full answer...
Changing the batteries in the TireMinder Smart TPMS for RVs - Signal Booster - 6 Tire Sensors, part # TPMS-APP-6, is a simple process. The sensor is threaded, so you can remove the cap. The battery is underneath the bridge that is under the sensor cap.
I have included a video review and a page from the installation manual explaining how to change the batteries below. view full answer...
Yes, the Goodyear G114 215/75R17.5 Tire w/ 17-1/2" Lynx Wheel and Sensor part # LH43FR does come with a pre-installed TPMS sensor. It works with TST TPMS monitors such as the Color Monitor for TST TPMS Systems part # TST-507-D-C. That's all that is needed, the wheel/tire/sensor combo and monitor. view full answer...
I spoke with Tuson about the Tuson Towable Tire Pressure Monitoring System part # 335TPMS4WIVS and they stated they do not condone the use of aftermarket TMPS tools to program their sensors. That said, the system comes pre-programmed but if you had to replace one of the sensors or they were not installed in the correct locations then you can use the Tuson TPMS Display Power Cable part # 335TPMS-DPCABLE which will allow you to pair the senors without having the vehicle close-by otherwise,... view full answer...
Yes, the TireMinder i10 TPMS for RVs and Trailers w/ Signal Booster part # TM29FR will display an error code "nos" if any of the sensors stop transmitting whether that be from a dead battery, out of range, etc. view full answer...
Yes, the Counteract Tire Balancing Beads # CA45FR will work perfectly with your TPMS, but you will need to remove the external sensor prior to injecting the beads. The only time that using these balancing beads with a TPMS gets tricky is when the TPMS is mounted on the inside of the tire - since yours is outside though you're good to go!
Attached is a review video of this kit for you to check out. view full answer...
Yes, the PressurePro FX 4 TPMS for RVs and Trailers # 372FX4K will be able to communicate with all 12 tires. This system can handle up to 40 tires.
The PressurePro FX 4 TPMS for RVs and Trailers # 372FX4K includes 4 sensors. You can use the Waterproof Sensors for PressurePro FX TPMS # 3722SEN to add the additional tire sensors. view full answer...
I reached out to the manufacturer, TST, about the Signal Booster for TST TPMS # TST-507-R, who told me the following:
1) The repeater does come with an inline fuse on the positive (red) wire.
2) All current repeaters do come with ring terminals.
3) When mounting the booster inside (such as in a bay) you can use any SPST (Single Pole Single Throw) switch.
For this I recommend the Pollak Heavy-Duty Toggle Switch - SPST- On-Off # PK34212.
The booster can be added to or used as a replacement... view full answer...
Since the maximum range of communication for the Tire Linc OneControl TPMS w/ Signal Booster for RVs and Trailers # LC37VR is 33 feet, with the repeater, it is going to be necessary. Lippert actually recommends staying under 25 feet from the repeater for the best signal strength.
As for turning off the repeater and sensors, all you have to do is close the app and after twenty minutes without use the sensors and repeater will go into sleep mode to preserve battery life. view full answer...
The TireMinder A1AS TPMS for RVs and Trailers w Signal Booster # TM86FR you're looking at are not waterproof, however the TireMinder i10 TPMS for RVs and Trailers w/ Signal Booster # TM56FR is.
This kit is a bit larger containing 10 sensors as oppose to 6, however you do get just about everything you'd get with # TM86FR minus the Bluetooth capabilities. view full answer...
To replace the batteries of the TPMS Cap sensors included with the TST TPMS for RVs - Color Display - Signal Booster - 6 Tire Sensors # TST-507-RV-6-C you will need to use the included wrench to turn the nut on the sensor counter clockwise. That will give you access to the CR2032 battery, and you can find replacements at a local hardware store.
When installing the new battery you will need to make sure the + side of the battery is facing up. Once its in place just make sure that the O... view full answer...
Yes, since iN-Command TPMS for RVs, Trailers, and Vehicles # NCTP100 are not flow-through sensors you're going to have to unscrew them to inflate your tires. view full answer...
As the booster in the Lippert Tire Linc OneControl TPMS w/ Signal Booster # LC37VR is just to make sure the sensors furthest from the source, everything will still work properly no matter where the booster is installed. The sensors will all connect directly to the smartphone app and there should be no issue not having the booster in the towed vehicle. view full answer...
The internal Tireminder sensors part # TM36FR that you referenced do not have replaceable batteries. Basically they last about 5 years with the non-replaceable battery and then would need to be replaced. view full answer...
The TireMinder TPMS for Single Axle Trailers # TPMS-TRL-2 will come with alligator clips as shown in the pictures.
It can be installed either with the alligator clips for a more temporary installation with quick removal. Or I recommend hard wiring it if you plan on using the sensors frequently with no risk of the device draining the battery. The alligator clips may fall off their connections when driving since they are held by spring tension. view full answer...
The only time you'll need to change out your tire stems to use the TireMinder TPMS for Dual Axle Trailers # TPMS-TRAILER is if they are in bad shape and need to be changed out anyways. I reached out to my contact at TireMinder and he said that the cap sensors in this kit only weigh in at 0.3oz so they are light enough they don't warrant metal valve stems.
He did say that some of their other kits use heavier sensors (standard is 0.5oz and flow-through are 0.7oz) and for those it is recommended... view full answer...
I reached out to my contact at Lippert and for the Tire Linc TPMS for RVs and Trailers w/ Signal Booster - Bluetooth - 4 Tire Sensors # LC37VR you were looking at to work you will need to have cell service or be connected to WiFi.
I included a video of the # LC37VR for you to take a look at. view full answer...
Yes. The Truck Systems Technologies TPMS for RVs # TST-507-RV-4-C has a low battery monitoring system will let you know when one of the batteries on the sensors is low or completely dead. I've attached a photo of the monitor that shows where you can find the Sensor Low Battery Alert on the screen as a reference. view full answer...
The # TST-507-FT-4-C TST TPMS for RVs - Color Display - Signal Booster - 4 Flow Through Tire Sensors works with metal (steel, chrome, nickel) valve stems. If you are using rubber valve stems they will not be covered under warranty. As for the metal valve stems, this will not be able to bend or break a metal valve stem.
I have attached a video review of the TPMS for your reference. view full answer...
Go To Results